fracture strength

基本解释

Methods 15 anterior ceramometal test full crowns were fabricated and 15 natural anterior teeth were selected. Fracture strength were measured.
制作15个前牙金瓷全冠，挑选15个离体前牙，测定其折裂时的强度。
Yield strength of in-situ MMCs is 28% and 95.7% higher, respectively than those of ex-situ MMCs and matrix aluminum, and fracture strength is increased by 20.6% and 88.5% correspondingly.
原位复合材料的增强效果明显，屈服强度比外加复合材料和基体分别高出28%和95.7%，断裂强度则相应提高了20.6%和88.5%；
The experimental results show that the fracture strength and strain first increase and then decrease with increasing the Ti content, and reaching the maximum value when Ti content is 5 at. %.
试验结果表明，随Ti含量增加，合金的断裂强度及断裂应变先增后降，在Ti含量为5at。%时达到最大值。

断裂强度
Compressed fracture strength increases from 467MPa to 580MPa, and fracture strain increases from 5.2% to 8.7% with increasing the Fe content from 0 to 7 at.
Fe含量从0 at.%增至7 at.%时,压缩断裂强度由467MPa增至580MPa,断裂应变由5.2%增至8.7%。
医药科学
断裂强度
The properties of these materials are highly dependent on the skills of the dental technicians. In addition, process-dependent microdefects reduce the fracture strength and increase the time-dependent failure probability of restorations.
传统的全瓷修复体通常是采用注浆成型、失蜡铸造或热压预先晶化的玻璃等方法制作的，采用这些方法所制作的修复体的质量，在很大程度上取决于牙科技师的个人技术，此外，在加工过程中所造成的微缺陷也降低了陶瓷材料的断裂强度，增加了修复体失败的几率。
机械工程
断裂强力
It later gives out the conclusion that both the fracture strength and hairiness meet with the requirement of warp knitting according to the test and theoretical calculation.
根据实际测量和理论计算,得出紧密纺高支棉纱的毛羽量和断裂强力均符合经编工艺的基本要求。
物理学
断裂强度
抗断强度
破裂强度